Tunghai University Institutional Repository:Item 310901/23925
English  |  正體中文  |  简体中文  |  全文笔数/总笔数 : 21921/27947 (78%)
造访人次 : 4216515      在线人数 : 400
RC Version 6.0 © Powered By DSPACE, MIT. Enhanced by NTU Library IR team.
搜寻范围 查询小技巧:
  • 您可在西文检索词汇前后加上"双引号",以获取较精准的检索结果
  • 若欲以作者姓名搜寻,建议至进阶搜寻限定作者字段,可获得较完整数据
  • 进阶搜寻


    jsp.display-item.identifier=請使用永久網址來引用或連結此文件: http://140.128.103.80:8080/handle/310901/23925


    题名: 1,4-丁二醇脫水製備四氫?喃觸媒之研究
    其它题名: Catalyst studies for 1,4-butanediol dehydration to tetrahydrofuran
    作者: 伍昭勳
    Wu,Zhao-Xun
    贡献者: 李國禎
    Li,Guo-Zhen
    化學工程與材料工程學系
    关键词: 1;dehydration;tetrahydrofuran;4-butanediol
    日期: 2013
    上传时间: 2014-02-19T01:53:20Z (UTC)
    摘要: 四氫?喃(THF)它是一種重要的化工原料及性能優良的溶劑,除了廣泛用於表面塗料、防腐塗料、印刷油墨和薄膜塗料的溶劑外,THF本身聚合成聚四氫?喃(PTMEG),用來製造彈性纖維。由於四氫?喃(THF)擁有廣泛用途,且生產之產品也具有經濟價值,因此,越受工業界所關注。本論文使用共沉澱法製備不同莫耳比的ZrO2-Al2O3觸媒、SiO2-Al2O3觸媒並探討此些觸媒催化1,4-丁二醇(BDO)脫水反應產生四氫?喃的性能。ZrO2-Al2O3觸媒催化1,4-丁二醇(BDO)脫水反應的最佳莫耳比為1:1,該觸媒0.4g在240?C下進行催化反應9hr,四氫?喃產率可達90.06%。而SiO2-Al2O3觸媒催化的最佳莫耳比為1:3,該觸媒在240?C下進行催化反應9hr,四氫?喃產率可達96.41%。我們利用X射線繞射儀(XRD)、傅立葉轉換紅外線光譜儀(FTIR)、熱場發射掃描式電子顯微鏡(TFSEM)、熱重分析儀(TGA)、表面積與孔洞分析儀(BET)、能量散射光譜儀(EDS)對混合雙金屬氧化物觸媒作特性分析,並探討脫水反應之活性和觸媒酸性之間關聯性。
    Tetrahydrofuran(THF) is a valuable industrial chemical and is a good solvent with exceptional function. It is not only widely used on solvent for surface paint, anticorrosive paint, printing ink, and film paint, but also can be used to produce polytetramethylene-ether-glycol(PTMEG). PTMEG is used to produce polyurethane elastane fiber. Tetrahydrofuran (THF) has extensive use, and its products also have high economic values. Therefore, it is much more concerned by the industrial sector.This thesis, uses coprecipitation method to prepare ZrO2-Al2O3 catalysts, and SiO2-Al2O3 catalysts for catalyzing 1,4 - butanediol (BDO) dehydration reaction to produce tetrahydrofuran. ZrO2-Al2O3 catalysts with Zr/Al atomic of 1/1 has the best performance for catalyzing BDO dehydration (at 0.4g catalyst,240?C,and 9hr, tetrahydrofuran yield is 90.06%). SiO2-Al2O3 catalyst with a Si/Al atomic ratio of 1/3 has the best catalytic performance (at 0.4g catalyst,240?C,and 9hr, tetrahydrofuran yield is 96.41%).We used XRD、FTIR、TFSEM、TGA、BET and EDS to characterise the mixed metal oxide catalysts. The correlation between dehydration activity and catalyst acidic properties were investigated.
    显示于类别:[化學工程與材料工程學系所] 碩博士論文

    文件中的档案:

    档案 大小格式浏览次数
    101THU00063022-001.pdf7689KbAdobe PDF1506检视/开启


    在THUIR中所有的数据项都受到原著作权保护.


    本網站之東海大學機構典藏數位內容,無償提供學術研究與公眾教育等公益性使用,惟仍請適度,合理使用本網站之內容,以尊重著作權人之權益。商業上之利用,則請先取得著作權人之授權。

    DSpace Software Copyright © 2002-2004  MIT &  Hewlett-Packard  /   Enhanced by   NTU Library IR team Copyright ©   - 回馈